Starter kit with up to 10 solenoids

from $136.00

This is the complete system with solenoids, solenoid life extender boards, the relay board (8 or 12 output) and power supply all ready to be installed. You can be up and running in just a few minutes with this setup, just unbox, plug in and install the DOF software (instructions on setting up DOF for visual pinball in below link)

I now also sell a less expensive but unassembled kit option. Check out the assembly instructions here: Kit assembly instructions and Kit assembly video Instructions. The kit comes with every screw, wire, terminal you need to assemble, you just need some wire strippers, a crimper (pliers can work in a pinch) and a screw driver.

If you purchased the full kit, the instructions for setting everything up and the files you need can be found here:

Sainsmart Board

PinOne Board

Relay Board:
Kit:
Number Solenoids:

This is the complete system with solenoids, solenoid life extender boards, the relay board (8 or 12 output) and power supply all ready to be installed. You can be up and running in just a few minutes with this setup, just unbox, plug in and install the DOF software (instructions on setting up DOF for visual pinball in below link)

I now also sell a less expensive but unassembled kit option. Check out the assembly instructions here: Kit assembly instructions and Kit assembly video Instructions. The kit comes with every screw, wire, terminal you need to assemble, you just need some wire strippers, a crimper (pliers can work in a pinch) and a screw driver.

If you purchased the full kit, the instructions for setting everything up and the files you need can be found here:

Sainsmart Board

PinOne Board

 

Specifications:

  • 120/240V switchable

  • USB Interface

Contents:

x1 Relay Board (PinOne Main Board/Sainsmart)

Mosfets (x11 PinOne or x7 Sainsmart)

Motor Control Chip (x1)

Solenoids (per selection)

Life Extenders (per selection)

12v 10A PSU (Not included in “Solenoid bars only option”

Terminal Connection Wires (per selection)

Mounting Boards

“Solenoid Bars Only” Option contains only the selected amount of Solenoids/Life Extenders with the Terminal Connection Wires

Hardware Install instructions can be found here: Install Instructions

Software instructions for the 8 output version: Install instructions

Software instructions for the 21 output version: Install Instructions

Recommended shaker motor can only be added to 8 channel board if you get 7 or less solenoids